HP 8.20q Fibre Channel Switch - Manual (Page 13)

HP StorageWorks Simple SAN Connection Manager user guide 13
2 Installing and removing Simple SAN Connection
Manager
This chapter provides procedures for installing Simple SAN Connection Manager on a Windows
management station, and for installing the required software components on other servers. It also provides
procedures for removing Simple SAN Connection Manager from a Windows system, as well as removing
the software components from Linux servers.
Installing Simple SAN Connection Manager
Use the HP StorageWorks Simple SAN Connection Manager CD to install the management software on
your management station as described in Windows installation , page 13. Then use the same CD to install
the HBA driver and other required software on each of the other servers in your SAN. Depending on the
server operating system for the non-management station installations, refer to either the steps for Windows
installation on page 13 or Linux installation on page 20.
Windows installation
Follow these steps to install the Simple SAN Connection Manager software on your management station,
or to install the required non-management software on all other servers running Windows.
To install Simple SAN Connection Manager on Windows:
1. Insert the installation CD into your computer’s CD-ROM drive.
The HP Installation Wizard starts automatically. (If the installer does not start automatically, run
Setup.exe
from the installation CD.)
The initial installation window ( Figure 2 ) opens.
Figure 2 Installation wizard: initial window
2. Click Next.