HP 8.20q Fibre Channel Switch - Manual (Page 46)

46 Managing switches
The Set the Switch Default Zoning dialog box ( Figure 29 ) opens.
Figure 29 Set the Switch Default Zoning dialog box
This dialog box contains the following information:
• Zone List—Shows the existing HBA zones with its HBA adapter and devices. If a zone list is closed
(the Switch Name, Port #, Type, and Vendor information is hidden), click the plus mark (+) to open
it.
• Switch Name (Port #)—Indicates the switch port number for each HBA and device.
• Type—Indicates the kind of device, for instance HBA or RAID storage.
• Vendor—Indicates the seller for the hardware indicated.
4. In the Default zone set name box, enter a name for the new default zone set.
5. To exclude a storage port from the new zone set, clear the check box next to the port name. To include
a storage port in the new zone set, select the check box next to it.
6. To save the new switch default zoning set up, click OK. To stop the switch zoning changes, click Cancel.
NOTE: To use other zoning schemes, launch the switch QuickTool application and set the zoning. To start
the switch QuickTool application, click the Physical Connection Map tab, right-click the switch icon, and
then on the shortcut menu, click Launch the switch QuickTool application.
Setting the switch admin password
Simple SAN Connection Manager provides a quick and easy way to set switch administrator passwords
within your SAN. These passwords are required for all update operations to be performed on the switch,
including:
• Updating firmware
• Setting switch symbolic name