HP NonStop G-Series - Manual (Page 40)

PortName Object Configuration
Workstation Configuration
2–12 110838 Tandem Computers Incorporated
Default
The default is the name of the PortName object you are configuring.
CommunicationsLibrary
Enter that name of the communications DLL provided with the Tandem DDE
Gateway. This must be RSCSHELL.DLL in the current release.
Default
The default value is RSCSHELL.DLL, so it is not necessary to specify this value in
this release.
DataConversionMappingLibrary
Enter the name of the data conversion related DLL provided with the Tandem DDE
Gateway. This must be TDMCVMAP.DLL in this release.
Default
The default value is TDMCVMAP.DLL, so it is not necessary to specify this value
in this release.
Examples
MOSCOW-PORT=C:\PORTS.INI, MOSCOW-CONFIG
DEFAULT=C:\PORTS.INI, DEFAULT-CONFIG
PORT16=
In the first two examples the PortConfigurationSection names are [MOSCOW-CONFIG]
and [DEFAULT-CONFIG] , respectively, in the PortConfigurationFile C:\PORTS.INI.
In the third example the PortConfigurationSection name defaults to [PORT16] and
the PortConfigurationFile name defaults to TDMGW.INI in the current directory in
effect when the Tandem DDE Gateway was started.
PortName Object
Configuration Section
For each PortName you declare in the [Ports] section, you can name a
PortConfigurationFile and a PortConfigurationSection where you configure the
attributes for the named port.
If you did not name a PortConfigurationFile and PortConfigurationSection in the
[Ports] section, then the default attributes for the port will be picked up from the file
and section with the default names.
You can specify the following attributes in the PortName object configuration section
for each configured PortName object:
Polling Interval
UmsPollingInterval
NumberOfInterprocessSessions
NumberOfIdsSessions
NumberOfUmsSessions