HP StorageWorks XP Remote Web Console Software - Manual (Page 94)

Table 52 Parameters for the ICKDSF Command (Version 2/Volume Copying) (continued)
Description Value Parameter Command
Specify the S-VOL and the
T-VOL of the relationship into
reverse.
• If you specify YES for
CHANGERECORDING,
only the updated part of
the S-VOL or the T-VOL of
the established
relationship will be
copied.
•
If you specify NO for
CHANGERECORDING
or specify nothing, only
the copied part from the
S-VOL to the T-VOL of the
established relationship
will be copied.
•
If you specify YES for
CHANGERECORDING,
the relationship will be
maintained after the
copying operation is
completed. If you specify
NO, or nothing, for
CHANGERECORDING,
the relationship will be
withdrawn after the
copying operation is
completed.
N/A FASTREVERSERESTORE or
FASTREVREST
The T-VOL can be set to
online after the relationship
is established.
The default setting of this
parameter is YES.
YES TGTCANCOMEONLINE or
TGTONLINE
The T-VOL cannot be set to
online until the relationship
is deleted. NO
To be specified when the
Version 2 T-VOL and the
TrueCopy for Mainframe
M-VOL are shared. YES TGTOKASPPRCPRIM
To be specified when the
Version 2 T-VOL and the
TrueCopy for Mainframe
M-VOL (or Universal
Replicator for Mainframe
P-VOL) are not shared.
NO is the default setting.
NO
Specifies the CU number, the
LDEV number, or the device
number of the S-VOL when
you use the Remote
FlashCopy function. CU number
LDEV number
Source device number
SOURCEVOL or SRCVOL
94 Performing Version 2 Operations