HP StorageWorks XP Remote Web Console Software - Manual (Page 91)

Figure 49 Copying All Datasets Using the COPY FULL Command (Version 2)
If the capacity of the copy source volume is larger than the capacity of the copy target volume,
and if REQUIRED is specified for the FASTREPLICATION parameter, the ADR920I message occurs
and the COPYcommand will end abnormally. In this case, perform one of the following:
•
Select the volume which has the same capacity as the copy source volume, and specify it as
the copy target volume.
•
Do not specify the FASTREPLICATION parameter.
•
Specify PREFERRED for the FASTREPLICATION parameter.
•
Specify NONE for the FASTREPLICATION parameter.
For detailed information about the ADR920I message, see the IBM documentation.
Establishing Version 2 Relationships by Volumes Using the ICKDSF Command
“Parameters for the ICKDSF Command (Version 2/Volume Copying)” (page 92) lists the parameters
you can use with the ICKDSF command when you establish Version 2 relationships by volumes.
Establishing Version 2 Relationships 91