HP StorageWorks XP Remote Web Console Software - Manual (Page 102)

Table 53 ANTRQST Macro Command Parameters (Version 2) (continued)
Description Value Parameter Command
The Remote FlashCopy
function is used to establish
a relationship. YES REMOTE
You do not use the Remote
FlashCopy function.
The Remote FlashCopy
function is not used to
establish a relationship.
NO
Specifies the TrueCopy for
Mainframe source device
number (device address).
Use this parameter when
REMOTE is YES.
TrueCopy for Mainframe
source device number DEVN
Specifies the serial number,
of the storage system
containing the S-VOL on
which you want to perform
the FCESTABLISH
command.
Use this parameter when
REMOTE is YES.
Serial number of the storage
system containing the S-VOL SRCSERIAL
Specifies the CU number of
the S-VOL on which you
want to perform the
FCESTABLISH
command.
Use this parameter when
REMOTE is YES.
S-VOL CU number SRCLSS
Specifies the LDEV number
of the S-VOL on which you
want to perform the
FCESTABLISH
command.
Use this parameter when
REMOTE is YES.
S-VOL LDEV number SRCDVC
Specifies the SSID of the CU
on which you establish the
FlashCopy relationship.
Use this parameter when
REMOTE is YES.
SSID SSID
Establishing Version 2 Relationships by Extents Using the TSO Command
When you establish Version 2 relationships by extents with the FCESTABL command, the following
parameters are available in addition to the parameters defined in
“Parameters for the FCESTABL
Command (Version 2/Volume Copying)” (page 84) .
102 Performing Version 2 Operations