HP StorageWorks XP Remote Web Console Software - Manual (Page 130)

Table 64 Information Displayed by the FCQUERY Command (Version 2) (continued)
Definition Displayed content Displayed item
Displays that the volume specified at DEVN is one of the following:
•
The volume is the source of the relationship, and the target is a normal
volume.
• The volume is the target of the relationship.
Not supported other than “N”.
N E
NOTE: If you are not sure if system option mode 20 is ON in your storage system, contact HP technical support. HP
technical support can determine the state of the system mode using your remote support connection.
1 In case the volume is set online in more than one LPAR defined by the mainframe system host.
Figure 84 Calculation Example for the Number of the Pairs Displayed in ACT
ACT shows the total number of the active Version 2 relationships in each extent. Therefore, in the
example in
“Calculation Example for the Number of the Pairs Displayed in ACT” (page 130) , the
total number of active Version 2 relationships in VOL#0 and VOL#1 is two, and 2 is displayed as
the content of ACT.
Figure 85 FCQUERY Command Example with the SHOWRELS parameter
FCQUERY DEVN(X'4202') SHOWRELS(ALL)
The result of the FCQUERY command with the SHOWRELS parameter is shown below. The rows
above the “RELATIONSHIP DETAIL STARTING TRACK” are the same as when the SHOWRELS
parameter is not specified. Table 8 15 (above) describes the content of these rows. Table 8 16
describes the content of the rows below “RELATIONSHIP DETAIL STARTING TRACK”.
130 Performing Version 2 Operations