HP StorageWorks XP Remote Web Console Software - Manual (Page 111)

Table 58 Results from FCWITHDR Command (continued)
Results Parameter Setting
The relationships established with the
specified copy target extents on the
volume specified by SDEVN are
withdrawn. DDSW parameter set to YES Unspecified
The command will do nothing and end
normally. Without any relevant relationships to
withdraw Unspecified
The FCWITHDR command will do
nothing and end normally. When the existing relationships do not
fall within the range specified by the
XTNTLST parameter Unspecified
There are several effective combination patterns of the parameters of the FCWITHDR command.
All combinations, other than those listed in
“Combinations of Parameters for the FCWITHDR
Command (Version 2)” (page 111) will result in rejection of this command. “Combinations of
Parameters for the FCWITHDR Command (Version 2)” (page 111) describes the parameters of the
FCWITHDR command and the applicable combinations.
Table 59 Combinations of Parameters for the FCWITHDR Command (Version 2)
Parameters Combination
ACTION XTNTLST DDSW DEVN TDEVN SDEVN
Target Source
Not specified Not
specified Not specified NO Not specified Specified Not specified “Case 1:
TDEVN
Specified,
DDSW =
NO”
(page 112)
Not specified Specified Specified NO Not specified Specified Not specified “Case 2:
TDEVN
Specified,
DDSW =
NO,
XTNTLST
Parameter
Specified”
(page 113)
Not specified Not
specified Not specified NO Not specified Specified Specified “Case 3:
SDEVN and
TDEVN
Specified,
DDSW =
NO”
(page 115)
Not specified Specified Specified NO Not specified Specified Specified “Case 4 (a,
b): SDEVN
and TDEVN
Specified,
DDSW =
NO,
XTNTLST
Parameter
Specified”
(page 116)
Releasing a Version 2 Relationship 111