HP Color LaserJet CM1015CM1017 Multifunction Printer series - Manual (Page 247)

FCC regulations
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant
to Part 15 of the FCC rules. These limits are designed to provide reasonable protection against harmful
interference in a residential installation. This equipment generates, uses, and can radiate radio
frequency energy. If this equipment is not installed and used in accordance with the instructions, it can
cause harmful interference to radio communications. However, there is no guarantee that interference
will not occur in a particular installation; the presence of interference can be determined by turning the
equipment off and on. If this equipment does cause harmful interference to radio or television
communications, the user is encouraged to try to correct the interference by one or more of the following
measures:
● Reorient or relocate the receiving antenna.
● Increase distance between equipment and receiver.
● Connect equipment to an outlet on a circuit different from that to which the receiver is located.
● Consult your dealer or an experienced radio/television technician.
NOTE Any changes or modifications to the MFP that are not expressly approved by HP could
void the user’s authority to operate this equipment.
Use of a shielded interface cable is required to comply with the Class B limits of Part 15 of FCC
rules.
ENWW FCC regulations 233