HP Color LaserJet CM1015CM1017 Multifunction Printer series - Manual (Page 133)

Menu item Description
USB speed
Less paper curl When printed pages are consistently curled, this option sets
the printer to a mode that reduces curl.
The default setting is Off.
Archive print When printing pages that will be stored for a long time, this
option sets the printer to a mode that reduces toner smearing
and dusting.
The default setting is Off.
Table 12-6 Network Configuration Menu (Available only on HP Color LaserJet CM1017 MFP Series)
Menu item Sub-menu item Description
TCP/IP configuration Automatic
Manual
Select Automatic to automatically
configure all the TCP/IP settings.
Select Manual to manually configure the
IP address, subnet mask, and default
gateway.
The control panel prompts you to specify
values for each address section. Press
Right arrow to increase the value.
Press Left arrow to decrease the value.
Press OK to accept the value and move
the cursor to the next field.
As each address is completed, the
printer prompts for address confirmation
before moving to the next one. After all
three addresses are set, the printer
automatically restarts.
Select Reset TCP/IP to restore all the
TCP/IP settings to the default values.
Link speed Automatic
10T Full
10T Half
100TX Full
100TX Half
The printer automatically detects the
correct link speed for the network. Use
this menu to set the link speed manually
if needed.
After setting the link speed, the printer
automatically restarts.
Memory card Sets memory card slots.
Restore defaults Resets all network configurations to their
factory defaults.
Table 12-5 Service Menu (continued)
ENWW Control-panel menus 119