HP StorageWorks XP Remote Web Console Software - Manual (Page 227)

•
DFW flag list (numeric): 0 = DFW not required; 1 = DFW required; default = 0. Must be
omitted for async pairs.
•
Error level list (string): “G” = group; “V” = volume; default = G. For sync pairs you must omit
this parameter.
•
Time-Saving Mode flag: “Yes” = The Use Time-Saving Mode option is enabled;
“No” = The Use Time-Saving Mode option is disabled; default = “Yes”. This parameter is a
non-list type and only one value can be specified.
•
Differential management measurement flag list (string): The differential between the volumes
is managed in cylinder (“Cylinder” or “C”) or in track (“Track” or “T”). When “Auto” or “A”
is specified, the storage system selects the differential management measurement (cylinder or
track) automatically. The default is Auto.
•
Time stamp transfer list (string): “Enable” = The host I/O time stamp is transferred from M-VOL
to R-VOL; “Disable” = The host I/O time stamp is not transferred from M-VOL to R-VOL; default
= “Disable”. For the async pairs you must omit this parameter.
“CreateHrcPair Command” (page 228) shows an example of the pair macro commands needed to
create the specified pairs with the parameters listed in “CreateHrcPair Parameters” (page 227) .
CAUTION: When using the CreateHrcPair command to create more than one pair, make sure
to keep each line within the maximum line length (320 bytes).
Table 77 CreateHrcPair Parameters
Value Parameter
_ilDevA M-VOL
_slWorkA Serial number (RCU)
11 SSID (RCU)
_ilDevB R-VOL
_slWorkB Initial copy pace
E Initial copy mode
S0, S0, S0 Sync level
[omit − N/A] CT group
_ilWorkA Priority
Never Fence level
0 CFW flag
1 DFW flag
[omit − N/A] Error level
[omit − default] Time-Saving Mode
Enable Time stamp transfer
Operation Macro Commands 227