HP Hitachi Dynamic Link Manager Software - Manual (Page 78)

HDLM Operations Using Commands
This section explains how to use the HDLM command. For details on the
various command operations, see Chapter 6, Command Reference on page
6-1 .
Notes on Using Commands
• Execute the HDLM command from the VMware vSphere CLI on the remote
management client.
• To specify a parameter value containing one or more spaces, enclose the
entire value in double quotation marks (").
• If you perform either of the following operations, the length of time
required to perform the operation (number-of-paths x one second)
depends on the number of paths that are managed by HDLM:
¢
An online or offline operation to change the status of paths
¢
A set operation to change the load-balance settings
Viewing Path Information
This section explains how to display path information by using an HDLM
command.
To display path information, execute the dlnkmgr command's view operation
with the -path parameter specified. The following example shows how to
execute the command:
dlnkmgr -s host-name -u user-name -p password view -path
To display information only for the paths accessing the specified host device,
execute the dlnkmgr command's view operation with the -path and -hdev
parameters specified. The following example shows how to execute the
command:
PROMPT>dlnkmgr -s host-name -u user-name -p password view -path -
hdev t10.HITACHI_770101520191
Paths:000002 OnlinePaths:000002
PathStatus IO-Count IO-Errors
Online 42 0
PathID PathName DskName
iLU ChaPort Status Type IO-Count IO-Errors DNum HDevName
000000 0002.0000.0000000000000000.0000 HITACHI .DF600F .77010152
0191 0B Online Own 42 0 0
t10.HITACHI_770101520191
000001 0005.0000.0000000000000000.0000 HITACHI .DF600F .77010152
0191 1B Online Non 0 0 0
t10.HITACHI_770101520191
KAPL01001-I The HDLM command completed normally. Operation name =
view, completion time = yyyy/mm/dd hh:mm:ss
4-2
HDLM Operation
Hitachi Dynamic Link Manager User Guide for VMware ®