HP Hitachi Dynamic Link Manager Software - Manual (Page 55)

VMware vSphere CLI 5.0/5.1 is a prerequisite program for a remote
management client. Make sure that VMware vSphere CLI is installed before
installing HDLM.
Storage Systems Supported by HDLM
HDLM supports the following storage systems:
If an FC-SAN is used:
• Hitachi AMS2000/AMS/WMS/SMS series
• Hitachi Universal Storage Platform V
• Hitachi Universal Storage Platform VM
• Hitachi Virtual Storage Platform
• HUS100 series
• HUS VM
• HP StorageWorks P9500 Disk Array
• XP20000/XP24000
If an IP-SAN is used:
• Hitachi AMS2000/AMS/WMS/SMS series
The supported storage systems require a dual controller configuration. If you
use the system in a HUB environment, you must set a unique loop ID for
every connected host and storage system. For details about the micro-
program versions for using HDLM, see the HDLM Release Notes. For details
about storage system settings required for using HDLM, see the maintenance
documentation for storage systems.
Memory and Disk Capacity Requirements
This section describes memory and disk capacity requirements.
Memory Requirements
The memory requirements for a host and remote management client are as
follows:
• Host
10 MB
• Remote management client
40 MB
Disk Requirements
The disk space requirements for hosts and remote management clients are as
follows:
• Host
Creating an HDLM Environment
3-3
Hitachi Dynamic Link Manager User Guide for VMware ®