HP XP Application Performance Extender Software - Manual (Page 23)

The Pre–installation summary is displayed. Follow the instructions to proceed.
Linux IA64 host
1. Transfer the P9000APEX_CAIA64.bin to the Linux IA64 host.
2. Run chmod +x P9000APEX_CAIA64.bin to grant execute permission to the
P9000APEX_CA.bin
file.
3. Run ./P9000APEX_CAIA64.bin.
The Welcome screen is displayed.
4. Click Next.
The following message is displayed:
An earlier version of APEX Communication Agent is installed on the
machine. Press OK to Upgrade.
5. Click OK.
The End User License Agreement is displayed.
6. Read and accept the terms of the agreement.
7. When prompted, enter the IP address of the management station.
The Pre–installation summary is displayed. Follow the instructions to proceed.
Windows host
1. Double-click P9000APEX_CA.exe to start the installation.
The Installation Wizard is displayed.
2. Click Next.
The following message is displayed:
An earlier version of APEX Communication Agent is installed on the
machine. Press OK to Upgrade.
3. Click OK.
The License Agreement window is displayed.
4. Read and accept the terms of the license agreement, and click Next.
5. When prompted, enter the IP address of the management station, and click Next.
The Pre–installation Summary window is displayed.
6. Click Install to proceed.
When the installation is complete, the Installation Summary window is displayed.
7. Click Done.
Upgrading the controller
Controller upgrade support
Table 3 shows upgrade support for P9000 Application Performance Extender controller versions. A
check mark ( ) indicates that you can perform an upgrade from the version in the FROM column
HP StorageWorks P9000 Application Performance Extender Software User Guide 23