HP XP Application Performance Extender Software User Manual
Page 17
NOTE:
On Linux hosts, ensure that the driver corresponding to the QLogic HBAs is listed as the first
uncommented entry in the /etc/hba.conf file.
•
For example, on 32 bit Linux hosts, if the /etc/hba.conf file includes the following entries:
lpfc
/usr/lib/libemsdm.so
qla2xxx
/usr/lib/libqlsdm.so
Change it to the following:
qla2xxx
/usr/lib/libqlsdm.so
lpfc
/usr/lib/libemsdm.so
•
On 64 bit Linux hosts, if the /etc/hba.conf file includes the following entries:
lpfc
/usr/lib/libemsdm.so
lpfc
/usr/lib64/libemsdm.so
qla2xxx
/usr/lib/libqlsdm.so
qla2xxx64
/usr/lib64/libqlsdm.so
Change it to the following:
qla2xxx64
/usr/lib64/libqlsdm.so
lpfc
/usr/lib/libemsdm.so
lpfc
/usr/lib64/libemsdm.so
qla2xxx
/usr/lib/libqlsdm.so
Installing the communication agent on a Linux IA64 host
To install the communication agent on a Linux IA64 host:
1.
Transfer the P9000APEX_CAIA64.bin to the Linux IA64 host.
2.
Run chmod +x P9000APEX_CAIA64.bin to grant execute permission to the
P9000APEX_CA.bin
file.
3.
Run ./P9000APEX_CAIA64.bin
The Welcome screen is displayed followed by the End User License Agreement.
4.
Read and accept the terms of the agreement.
5.
When prompted, enter the IP address of the management station.
NOTE:
Ensure that you enter the correct IP address of the management station.
The Pre–installation summary is displayed. Follow the instructions to proceed.
Verifying communication agent installation on HP-UX and Linux hosts
HP-UX
To verify that the communication agent was installed successfully, run the following command to check
the status:
/sbin/init.d/apex_ca status
HP StorageWorks P9000 Application Performance Extender Software User Guide
17