HP XP Application Performance Extender Software - Manual (Page 16)

Installing the communication agent on HP-UX and Linux (x86 and x86_64) hosts
NOTE:
If the HP-UX PHKL_40311 cumulative patch is not installed, the following message is displayed:
Please contact HP service to install the "asyncdsk cumulative patch"
to get APEX support for I/Os through HP-UX asyncdsk driver. If you do
not need support for HP-UX asyncdsk driver or you will get this patch
installed later, you can continue with this installation. APEX would
not support I/Os through HP-UX asyncdsk driver without this patch.
To install the communication agent on HP-UX and Linux (x86 and x86_64) hosts:
1. Transfer the P9000APEX_CA.bin to the HP-UX or Linux host.
2. Run chmod +x P9000APEX_CA.bin to grant execute permission to the P9000APEX_CA.bin
file.
3. Run ./P9000APEX_CA.bin
The Welcome screen is displayed followed by the End User License Agreement.
4. Read and accept the terms of the agreement.
5. When prompted, enter the IP address of the management station.
NOTE:
Ensure that you enter the correct IP address of the management station as host names are not
supported.
The Pre–installation summary is displayed. Follow the instructions to proceed.
The communication agent is installed in the /opt/Hewlett-Packard/apex/com_agent directory.
Installing and removing P9000 Application Performance Extender 16