HP StorageWorks XP Remote Web Console Software - Manual (Page 92)

Description Item
Set an IPv4 address, an IPv6 address, or a host name of the mail server.
• To set an IPv4 address, select IPv4 and enter four integers in the range of 0 to 255
(for example,
nnn.nnn.nnn.nnn , where n is a number).
• To set an IPv6 address, select IPv6 and enter eight hexadecimal numbers in the
range of 0 to FFFF (for example,
hhhh:hhhh:hhhh:hhhh:hhhh:hhhh:hhhh:hh-
hh , where h is a hexadecimal digit). Enter 0 to omit a segment.
• To set a host name, select Host Name and enter up to 63 alphanumeric characters
(ASCII codes) and symbols, except for the following symbols and a space.
" \ ; : , * ? < > | / # & + = [ ] ' { } ^
Mail Server
Specify whether to use SMTP authentication.
• Enable: Uses SMTP authentication.
• Disable: Does not use SMTP authentication.
SMTP-AUTH
Set the account and password for SMTP authentication. Required when SMTP-AUTH is
Enable. Enter up to 255 alphanumeric characters and symbols (ASCII codes) for user
ID and password, except for the following symbols and a space.
" \ ; : , * ? < > | / # & + = [ ] ' { } ^
Account and Pass-
word
Specify an e-mail address of the sender. Enter up to 255 alphanumeric characters
(ASCII codes) and symbols ( ! # $ % & + - * / ' ^ { } _ . ).
From Address
Specify a Reply-To address of email. If you specify this address, replies from the email
receivers will be sent to this address. If you omit this address, replies from the email
receivers will be sent to From Address. The available values are the same as those of
From Address.
Return Address
Specify e-mail addresses of the receivers and the attributes (To, Cc, or Bcc). Up to 32
addresses can be specified. The available values are the same as those of From Address.
To Address
When you click Test Send, test e-mails are sent to the e-mail addresses of the receivers.
This button is available only in Modify mode.
Test Send button
Implements all the settings made on the E-mail Information window. This button is
available only in Modify mode.
Apply button
Cancels all the settings made on the E-mail Information window. This button is available
only in Modify mode.
Cancel button
Configuration File Loader Window
The Configuration File Loader window allows you to export a spreadsheet file with the current
configuration information, and import a file with the new configuration. You can also see the status
and the error information for the imported file before you apply the changes. For the procedure in
the Configuration File Loader window, see “
Using Configuration File Loader ” on page 131.
To open the Configuration File Loader window, log in to the Remote Web Console, and then select
Go, Configuration File Loader and Configuration File Loader from the menu bar of the Remote Web
Console main window. Storage partition administrators cannot display the Configuration File Loader
window.
Using the Remote Web Console GUI 92