HP Surestore 64 Director Switch - Manual (Page 62)

50 config
config.zoning
Note that the config.zoning commands function in a different way from the other CLI
commands, which are single action commands that take effect immediately. A zoning
configuration is typically too complicated to be described by a single command, so the first
zoning command entered invokes a work area editor. The commands take effect on a
temporary copy of a zone set in the work area until the temporary copy in the work area is
activated to the fabric--or is discarded.
Because not all the verification of the zone set can occur on the temporary copy in the
work area, it is possible, however unlikely, that the copy of the zone set encounters no
errors until the zone set is activated to the fabric.
config.zoning.setDefZoneState
Syntax
setDefZoneState defaultZoneState
Purpose
This command enables or disables the default zone and takes effect immediately fabric
wide.
Description
Note This command takes effect immediately in the fabric.
Parameters
This command has one parameter.
defaultZoneState Specifies whether the default zone is enabled. Valid values are true and
false . Boolean 1 and 0 may be substituted as values.