HP Surestore 64 Director Switch - Manual (Page 16)

4 Entering Command Line Interface Commands
Command Tree
The command tree of the Command Line Interface begins from the root. The commands in
the four extended branches (config, maint, perf, and show) are described in Chapter 2, CLI
Commands.
There are three additional commands (login, logout, and commaDelim) that are globally
available commands. These commands are described in this chapter.
^A Control-A Position the cursor to the start of the line.
^B Control-B Position the cursor left one character.
^D Control-D Delete the current character.
^E Control-E Position the cursor to the end of the line.
^F Control-F Position the cursor right one character.
^H Control-H Backspace one character and delete the
character.
^I Tab Complete the current keyword.
^K Control-K Delete to the end of the line.
^L Control-L Redraw the line.
^N Control-N Move down one line in the command history.
^P Control-P Move up one line in the command history.
^R Control-R Redraw the line.
^U Control-U Clear the input and reset the line buffer.
^X Control-X Clear the input and reset the line buffer.
[A Up Arrow Move up one line in the command history.
[B Down Arrow Move down one line in the command history.
[C Right Arrow Position the cursor right one character.
[D Left Arrow Position the cursor left one character.
Table 1 CLI Command Tree Navigation Conventions (cont’d)
Character Sequence Common Name Action or Description