HP Surestore 64 Director Switch - Manual (Page 37)

config 25
CLI Com
m
a
nds
config.port.name
Syntax
name portNumber “portName”
Purpose
This command sets the name for a port.
Parameters
This command has two required parameters.
Command Example
Root> config port name 4 “Sam’s tape drive”
config.port.type
Syntax
type portNumber portType
Purpose
This command sets the allowed type for a port.
Description
A port can be configured as an F_Port, an E_Port, or a G_Port. If a port is configured as an
F_Port, that port cannot be used as an interswitch link, but may attach to a device with an
N_Port. If a port is configured as an E_Port, only other switches may attach to that port. If
a port is configured as a G_Port, either a device or another switch may attach.
portNumber Specifies the port number. Valid values are:
0–63 for the FC-64
portName Specifies the name for the port. The port name must not exceed 24
characters in length.