HP Surestore 64 Director Switch - Manual (Page 120)

108 Appendix
Error 228: Invalid Write
Authorization Argument The writeAuthorization parameter of the
config.snmp.addCommunity command does not contain a valid
value. For example, the value is
true or false . Valid values for
the writeAuthorization parameter are enabled and disabled .
Boolean 1 and 0 may be substituted as values.
Error 229: Invalid UDP Port
Number The udpPortNum parameter of the config.snmp.addCommunity
command does not contain a valid value. Valid values for the
udpPortNum parameter are decimal numbers; the default value
is 162. Valid values include all legal UDP port numbers.
Error 230: Invalid WWN The wwn parameter does not contain a value in the proper
format. For example, the wwn parameter of the
config.zoning.addWwnMem or config.zoning.deleteWwnMem
command does not contain a value in the proper format. The
world-wide name of the member to be added to the zone must
be in colon-delimited hexidecimal notation. Enter a WWN in the
proper format, for example, AA:00:AA:00:AA:00:AA:00.
Error 231: Invalid Port Number
Error 232: Invalid Domain ID The value entered for the domain ID is invalid. For example, the
domainId parameter of the config.switch.prefDomainId quires an
integer in the range 1–31. Enter a valid value for the domain ID
parameter of the command. Refer to Chapter 2, CLI Commands
for the description of CLI command parameters.
Error 233: Invalid Member
Error 234: Invalid Command The entered command is misspelled or the prompt is not
positioned at the right place in the CLI command tree for entering
this command. Ensure that the command is spelled correctly.
Refer to Chapter 2, CLI Commands for the correct spelling of the
command.
Ensure that the command has been entered at the right place in
the CLI command tree (see Navigation of the CLI Command
Tree on p. 8).
Error 235: Unrecognized
Command
Message Cause/Solution