HP Surestore 64 Director Switch - Manual (Page 42)

30 config
config.security.portBinding.show
Syntax
show portNumber
Purpose
This command shows the port binding configuration for a single port.
Parameters
This command has one parameter.
Command Example
Root> config security portBinding show 4
Output
The port binding configuration date is displayed as a table that includes the following
properties.
portNumber Specifies the port number for which the port binding configuration will be
shown. Valid values are:
0–63 for the FC-64
Port Number The port number.
WWN Binding The state of port binding for the specified port, either active or inactive.
Bound WWN The WWN of the device that is bound to the specified port. If this field is
blank, no device has been bound to the specified port.