HP Surestore 64 Director Switch - Manual (Page 34)

22 config
Note If the IP address is reconfigured, your Telnet client must be reconnected to the
new IP address. A new login will be requested.
Parameters
This command has three parameters.
Command Example
Root> config ip ethernet 10.0.0.0 0.0.0.0 255.0.0.0
config.ip.show
Syntax
show
Purpose
This command shows the LAN configuration.
Parameters
This command has no parameters.
Command Example
Root> config ip show
ipAddress Specifies the new IP address for the director or switch. The address must be
entered in dotted decimal format (for example, 10.0.0.0).
gatewayAddress Specifies the new gateway address for the Ethernet interface. The address
must be entered in dotted decimal format (for example, 0.0.0.0).
subnetMask Specifies the new subnet mask for the Ethernet interface. The address must
be entered in dotted decimal format (for example, 255.0.0.0).