HP 3PAR Service Processors - Manual (Page 55)

5.7 Managing Connection Portal Controls
3PAR Service Processor User’s Guide
3 Type the static IPv4 address assigned to the domain server or none and press ENTER .
4 Based upon the planning document(s), enter the specific confirmation to proceed with
allowing 3PAR Secure Service Policy Manager to communicate with 3PAR Secure Service
Collector.
5 Type yes to allow remote access to the Service Processor (SP).
6 Verify the data is correct and type yes to confirm.
Please enter the IPv4 address (or blank separated list of addresses) of the
Domain Name Server(s)
or 'none' if there will not be any DNS support: [?]:
or none
Will a 3PAR Secure Service Policy Manager be used with this 3PAR Secure
Service Collector Server? (yes or no) [yes]:
no or yes
Remote access to this Service Processor would normally be controlled
by the 3PAR Secure Service Policy Manager. Since there will not be one,
the ability to
remotely access this SP will be controlled by a configuration setting
of the local SSAgent.
Will remote access to this Service Processor be allowed (yes or no)?
[yes]:
yes
3PAR Secure Service Policy Manager
- Name/address: none
- Remote access: Allowed
Is this data correct? (yes or no)? [yes]
yes