HP 3PAR Service Processors - Manual (Page 28)

3.6 Changing the Service Processor Netmask
3PAR Service Processor User’s Guide
3.7 Changing the Service Processor Netmask
To change the Service Processor netmask, type the following menu options from the SPMAINT
main menu:
1 From the SPMAINT main menu, type 2 for Network Configuration and press ENTER .
2 Type 4 for Change public network interface parameters and press ENTER .
3 Type 4 for Change Netmask and press ENTER .
4 The Modify Netmask menu appears, type a new netmask and press ENTER .
3.8 Changing the Service Processor Default Gateway
The IP address of the device on the local (public) network segment (or subnet), acts as a route
to the rest of your network. Typically, the IP address of the device is the same address as the
default route (see 3.5 Changing the SP Default Route ). However, for some networks, where
Routing Information Protocol (RIP) is disallowed, it may be necessary to define a separate
device for this function.
To change the Service Processor default gateway:
1 From the SPMAINT main menu, type 2 for Network Configuration and press ENTER .
2 Type 4 for Change public network interface parameters and press ENTER .
3 Type 5 for Change Gateway and press ENTER .
4 Type a new gateway and press ENTER .
5 The SP Network submenu appears, and the new default gateway address appears to the
right of the current gateway address. Type A and press ENTER to quit, save, and activate the
new default gateway address.