HP ProLiant DL740 Server - Manual (Page 93)

Installing Hardware Options, Non-Hot-Plug
HP has designed a self-latching slot-keeper feature to accommodate
full-length expansion boards.
Be sure that the V-shaped slot-keeper tabs on the plastic expansion board guide
are positioned over the forward end of the expansion board. Using the slot
keepers is especially important when expansion boards are added or when the
server is moved.
Figure 4-8: Full-length self-latching slot-keeper feature
6. Close the top access panel, and slide the server into the rack.
7. Connect all power cords and power up the server (refer to Chapter 7).
8. If necessary, run the ROM-Based Setup Utility, as described in Chapter 8.
NOTE: For a list of supported I/O expansion boards, refer to the HP QuickSpecs for the
ProLiant DL740 servers at
www.hp.com/products/servers/platforms .
NOTE: Each PCI-X bus is automatically configured to run in the most advanced mode
(PCI-X or PCI) and the highest frequency supported by all expansion boards installed in the
slots on the bus.
HP ProLiant DL740 Server User Guide 4-11
HP CONFIDENTIAL
Writer: Anna Roberts File Name: e-ch4 Install Hardware Options Non Hot-Plug.doc
Codename: Expedition Part Number: 270854-002 Last Saved On: 6/17/03 2:07 PM