HP ProLiant DL740 Server - Manual (Page 196)

Configuring the Server
Configuring the Drive Array Controller
If you are using a simple SCSI controller to boot from the internal drives, disregard
this section and proceed to the “Installing the Operating System” section later in this
chapter. If you are using a Smart Array 5i Controller or an array controller installed
in a PCI/PCI-X slot to boot from the internal drives the first time the system is
powered up, you must create the logical drive (or drives) in the RAID array.
The Smart Array 5i Controller built into the ProLiant DL740 server can use any of
the following utilities to create logical drives based on the RAID configuration that
you specify:
• Option ROM Configuration for Arrays (ORCA)
• Array Configuration Utility (ACU)
• Array Configuration Replicator Utility (ACR)
The Smart Array 5i Controller is a dual-channel Ultra3 SCSI array controller
embedded on the I/O board. Both channels support Low Voltage Differential (LVD)
SCSI devices. The controller provides the following features:
• 32 MB of total memory with 12 MB of read-ahead cache
• Support for up to four internal Ultra3 SCSI hot-plug drives in RAID 0, 1, 1+0,
and 5 configurations
• External connector support for external tape drives to back up the internal drives
• Migration between RAID levels
• Migration between stripe sizes
• Prefailure notification and Pre-Failure Warranty (through Insight Manager 7)
• Online spares
Port 2 is dedicated to controlling the SCSI drives in the internal drive bay.
8-16 HP ProLiant DL740 Server User Guide
HP CONFIDENTIAL
Writer: Anna Roberts File Name: i-ch8 Configuring the Server.doc
Codename: Expedition Part Number: 270854-002 Last Saved On: 6/17/03 2:16 PM