HP ProLiant DL740 Server - Manual (Page 90)

Installing Hardware Options, Non-Hot-Plug
Table 4-1: I/O Expansion Slots
Item Description
Slots 1–2 PCI bus 7—Supports 64-bit PCI-X expansion boards at 100 MHz;
it is keyed for 3.3v signaling.
Slots 3–4 PCI bus 11—Supports 64-bit PCI-X expansion boards at 100 MHz;
it is keyed for 3.3v signaling.
Slots 5–6 PCI bus 3—Supports 64-bit PCI-X expansion boards at 100 MHz;
it is keyed for 3.3v signaling.
7 PCI-X hot-plug switchboard cable connector
8 I/O board switch bank (SW7)
9 Array enabler board
Note: The operating system detects PCI devices in the following slot order: 5-6-1-2-3-4.
The I/O expansion slots are distributed among three separate PCI-X buses.
Adding Non-Hot-Plug Expansion Boards
You can use non-hot-plug expansion boards in the ProLiant DL740 server, but you
must install them according to the following procedure. To prepare the server:
1. If this is the first time you have powered up the server, skip to step 4. If you have
previously powered up the server, back up the server data.
2. Shut down the operating system as directed in your operating system instructions.
3. Power down the server (refer to Chapter 7).
4. Disconnect the power cords from the server.
5. Slide the server out of the rack.
6. Open the top access panel, as shown in Chapter 3.
4-8 HP ProLiant DL740 Server User Guide
HP CONFIDENTIAL
Writer: Anna Roberts File Name: e-ch4 Install Hardware Options Non Hot-Plug.doc
Codename: Expedition Part Number: 270854-002 Last Saved On: 6/17/03 2:07 PM