HP ProLiant DL740 Server - Manual (Page 125)

Installing Hardware Options, Hot-Plug
Installing a Hot-Plug SCSI Hard Disk Drive
CAUTION: Before adding or removing any hot-plug SCSI drives, consult the
operating system instructions. Failure to do so could result in loss of data or damage
to equipment.
To install a hot-plug SCSI hard drive:
1. Remove the blanking panel in an unused drive bay by pushing the sides of the
retaining clips inward (1), and then pull the blanking panel outward (2), as shown
in Figure 5-11.
Figure 5-11: Removing a hard-drive blanking panel
2. Push the release button on the left of the new drive and rotate the hot-plug drive
ejector lever outward to unlock the drive.
5-26 HP ProLiant DL740 Server User Guide
HP CONFIDENTIAL
Writer: Anna Roberts File Name: f-ch5 Installing Hardware Options Hot-Plug.doc
Codename: Expedition Part Number: 270854-002 Last Saved On: 6/17/03 2:09 PM