HP ProLiant DL740 Server - Manual (Page 88)

Installing Hardware Options, Non-Hot-Plug
7. Insert the processor board into processor board slot 2 of the module (1).
8. Push down the processor board lever until it is secured by the lever latch (2).
Figure 4-4: Installing the processor board
9. Close the top access panels.
NOTE: Processor board 2 need not be installed for the server to run. If only one
processor board is installed, be sure the processor board air baffle is in place to provide
optimal airflow.
10. Connect all power cords and power up the server. If the system does not power
up, verify that the system interconnect LEDs are normal. Refer to the section,
“System Interconnect Status Indicators” in Chapter 7.
11. Be sure that the processor has been installed correctly. Check the processor
speed, cache size, and socket location by reviewing the POST messages on the
system console.
4-6 HP ProLiant DL740 Server User Guide
HP CONFIDENTIAL
Writer: Anna Roberts File Name: e-ch4 Install Hardware Options Non Hot-Plug.doc
Codename: Expedition Part Number: 270854-002 Last Saved On: 6/17/03 2:07 PM