HP ProLiant DL740 Server - Manual (Page 211)

Software Management
To set the iLO Security Override Switch:
1. Power down the server and remove AC power cords. Refer to Chapter 7 for
instructions.
2. Open the top access panels to gain access to the host module. Refer to Chapter 3
for instructions.
3. Locate switch bank 7 (SW7) on the I/O board.
Figure 9-3: Location of SW7 on the I/O board
4. Set switch 8 in switch bank 7 (SW7) to the enabled position.
5. Press the Power/On Standby switch to power on the server.
6. Log on to the iLO and reset the passwords.
A warning message will be displayed on the iLO Web pages indicating that the iLO
Security Override function is currently active. An iLO log entry will be added
recording the use of the iLO Security Override. An SNMP alert may also be sent
upon setting or clearing of the iLO Security Override function.
9-6 HP ProLiant DL740 Server User Guide
HP CONFIDENTIAL
Writer: Anna Roberts File Name: j-ch9 Software Management.doc
Codename: Expedition Part Number: 270854-002 Last Saved On: 6/17/03 2:25 PM