HP ProLiant DL740 Server - Manual (Page 151)

Installing Hardware Options, Hot-Plug
4. Press on the top (1) of the appropriate expansion slot release lever and open the
slot-keeper lever toward the front (2) of the expansion slot.
5. Unseat the expansion board by pulling up on the plastic tab on the slot divider for
that slot (3), and then lift the board out of the server (4).
Figure 5-25: Removing an I/O expansion board
6. If you are only removing the board and not replacing it, install an expansion slot
cover. Close the slot release lever. Be sure that the lever latches into the closed
position.
7. If you are replacing the board, install the new I/O expansion board.
8. Close the slot release lever. Be sure that the lever latches into the closed position.
9. Reconnect any I/O cables to the new board.
10. Return power to the slot through the PCI Hot Plug button or software application.
The green LED will flash during the power-up transition and will turn solid when
the power-up is complete. For more information about PCI Hot Plug LEDs, refer
to “PCI Hot Plug LED Indicators” earlier in this chapter.
11. Close the top access panels.
5-52 HP ProLiant DL740 Server User Guide
HP CONFIDENTIAL
Writer: Anna Roberts File Name: f-ch5 Installing Hardware Options Hot-Plug.doc
Codename: Expedition Part Number: 270854-002 Last Saved On: 6/17/03 2:09 PM