HP StorageWorks 8000 NAS - Manual (Page 219)

Command View SDM Limitations 217
Co
mma
nd
V
iew
SDM
Lim
ita
tio
ns
Configuration General Settings Alias Name No Limitations
Data
Resiliency
Warning: This is set to Normal. Do not
changes this setting. Changing this can
affect the integrity of the data in the event
of a system crash or power failure.
Automatic
Include
Do not turn this feature off. New disc
drives may not be recognized.
Auto Format
Drive
Do not turn this feature off. New disc
drives may not be available.
Subsystem
Level RAID
Control
This is set to AutoRAID. You may choose
any setting. Be sure to understand the
storage capacity & performance
implications before changing this setting.
Hot Spare
Mode
This is set to Automatic. Do not change this
setting to None. An active spare should be
present to ensure data integrity in the
event of multiple drive failures.
Queue Full
Threshold
Do not change this setting.
Port ID This setting should be altered when
multiple storage arrays are attached via a
switch to ensure that each array is given a
unique ID. This is done using the virtual
front panel at hardware setup time. This
should be performed by an qualified HP
technician.
Port Behavior Do not change this setting or attached
arrays will not be visible to the NAS
server.
Port Topology Do not change this setting or attached
arrays will not be visible to the NAS
server.
Table 1 Command View SDM Limitations
Tab Page Feature Limitations