HP StorageWorks 8000 NAS - Manual (Page 188)

186 NAS 8000 System and Hardware Upgrades
Assigning IP Addresses
After you have installed NICs, you must assign IP addresses.
1 In the Command View NAS web interface, click the Configuration tab.
2 Navigate down the tree to Networking Settings > TCP/IP and select IP
Addresses. Your current NIC configuration is displayed.
3 Enter the IP address for the new NICs in the address location field.
For more information, see “Defining IP Addresses” on page 54.
Firmware Upgrades
Upgrading the firmware of the NAS server requires attaching a keyboard
and monitor. See the HP Netserver LT6000r support site to acquire the
necessary disk images and upgrade instructions:
■ Firmware upgrades http://www.hp.com/support/nas8000
Standard Server Upgrades
Additional standard upgrades may be made to the NAS server. These
upgrades do not require any additional configuration of the HP NAS 8000
solution. Please contact your HP support representative for information
regarding supported server configurations.
For additional upgrade information, see:
■ Accessories and upgrades http://www.hp.com/support/nas8000
■ Replaceable parts http://www.hp.com/support/nas8000