HP Array Controller HSG V8.7 Software - Manual (Page 43)

Operating the UltraSCSI Enclosure
UltraSCSI RAID Enclosure 2–7
Turning On the Subsystem
After completing subsystem assembly, expansion, or movement of
the subsystem, complete the procedure in Table 2–2 to turn it back
O
N .
Table 2–2 Turning On the Subsystem Power
1. If there are no expansion enclosures, go to step 2.
If there are expansion
enclosures, turn O
N all the ac
input boxes for each
expansion enclosure by
pressing I on each ac power
switch (C
ALLOUT 1).
2. On the master enclosure,
turn O
N all the ac input
boxes by pressing I on each
ac power switch
(C
ALLOUT 1).
3. Verify the array controller places the subsystem into an operational
state.
1
0
CXO5488B
2
1