HP Array Controller HSG V8.7 Software - Manual (Page 159)

Storage Devices
UltraSCSI RAID Enclosure 7–13
6. If performing a cold swap, determine if there are expansion
enclosures. If there are no expansion enclosures, go to step 7.
If there are expansion
enclosures, turn O
FF all the
ac input boxes for each
expansion enclosure by
pressing O on each ac power
switch (C
ALLOUT 1).
7. On the master enclosure,
turn O
FF all the ac input
boxes by pressing O on each
ac power switch
(C
ALLOUT 1) and then go to
step 14.
8. Install all the disk drive SBB
devices, starting in the lower
left corner in shelf 1 (devices 1
through 6) and advancing to the
right.
9. Starting from the left, install all the disk drive SBB devices in shelf 2
(devices 7 through 12).
10. Starting from the left, install all the disk drive SBB devices in shelf 3
(devices 13 through 18).
Table 7–4 Installing a Disk Drive SBB (Continued)
1
0
CXO5488B
2
1
17
11
CXO5811B
19 20 21 22 23 24
13 14 15 16 18
7 8 9 10 12
1 2 3 4 5 6
A B
4A
3A
2A
1A
3B
2B
1B
4B Shelf 4
Shelf 3
Shelf 2
Shelf 1
1 2