HP Array Controller HSG V8.7 Software - Manual (Page 166)

Enclosure Blowers
8–6 UltraSCSI RAID Enclosure
Table 8–2 Installing a Blower
1. Verify that the blower is a model DS–BA35X–MK.
2. Orient the replacement
blower to align its
connector (C
ALLOUT 2)
and guide pin (C ALLOUT 1)
with the backplane blower
connector.
3. Push the blower straight in, until the upper and lower mounting tabs
(C
ALLOUTS 3 and 4) snap into place.
4. If dc power is applied to the enclosure, verify that the blower starts
operating.
CXO5753B
1
2 3
4