HP Array Controller HSG V8.7 Software - Manual (Page 116)

Single-Ended I/O Module
5–14 UltraSCSI RAID Enclosure
10. On the expansion enclosure shroud, align the module that has Cable
A (C ALLOUT A) attached with the Port 1 backplane connector.
Gently insert the module and fully seat it. Use a screwdriver to
tighten the spring-loaded mounting screws.
11. Repeat steps 5 through 10 for the remaining SCSI buses (ports 2
through 6).
12. Turn O N the subsystem using Table 5–7 and verify that it is operating
properly.
Table 5–6 Installing Two-Enclosure Subsystem
Cables (Continued)
CXO5840B
6 4 2
5 3 1
6 4 2
5 3 1
A