Ultrascsi enclosures, Figure 2–1 power supply bezel label, Enclosure addressing – HP Array Controller HSG V8.7 Software User Manual
Page 40: Ultrascsi enclosures –4 enclosure addressing –4, Figure 2–1 power supply bezel label –4
Operating the UltraSCSI Enclosure
2–4 UltraSCSI RAID Enclosure
UltraSCSI Enclosures
The following configuration rules apply to UltraSCSI RAID
subsystem enclosures:
•
The only compatible ac input box is model DS–BA35X–HE.
•
The only compatible power supply is model DS–BA35X–HH
(180 W). The bezel label shown in Figure 2–1 identifies these
power supplies.
Figure 2–1
Power Supply Bezel Label
Enclosure Addressing
The following configuration rules apply to the UltraSCSI RAID
enclosure address settings:
•
The enclosure containing the array controller is the master
enclosure. The PVA SCSI ID switch setting for the master
enclosure is always 0.
•
UltraSCSI subsystem expansion enclosures use either PVA SCSI
ID switch setting 2 or 3:
— The first expansion enclosure switch setting is always 2.
— The second expansion enclosure switch setting is always 3.
CXO5926A