HP Array Controller HSG V8.7 Software - Manual (Page 185)

Installing EMU Microcode
UltraSCSI RAID Enclosure C–3
5. Use the PROCOMM PLUS Setup Utility to establish the following
parameters for modem and protocol options:
Modem Options
General Options
Auto baud detect OFF
Send init if CD high NO
Protocol Options
General Options
Abort xfer if CD lost NO
ASCII Protocol Options
Character pacing (millisec) 0
Line pacing (1/10 second) 0
Pace character 0
Strip 8
th
bit NO
CR translation (upload) NONE
LF translation (upload) NONE
6. Insert the microcode disk into the disk drive. Copy the EMU
microcode file into a PC directory (for example,
C:\FLSH_011.HEX).
7. Start the communications program.
Table C–1 Preliminary Procedures (Continued)