HP Array Controller HSG V8.7 Software - Manual (Page 121)

Single-Ended I/O Module
UltraSCSI RAID Enclosure 5–19
11. Install a wire tie through the holes on the cable support bracket and
around the cable. Tighten the wire tie.
12. On the first expansion enclosure shroud, align the module that has
Cable B (C ALLOUT B) attached with the Port 1 backplane connector.
Gently insert the module and fully seat it. Use a screwdriver to
tighten the spring-loaded mounting screws.
13. On the second expansion
enclosure I/O module,
align the Cable B
(C
ALLOUT B) connector
with the left connector.
Gently insert the cable
connector into the module
connector. Tighten both
cable connector thumb
screws to fully seat the
connector.
14. Install a wire tie through the holes on the cable support bracket and
around the cable. Tighten the wire tie.
Table 5–8 Installing Three-Enclosure Subsystem
Cables (Continued)
6 4 2
5 3 1
6 4 2
5 3 1
6 4 2
A
B
CXO5854B
A