HP ProLiant DL170e G6 Server - Manual (Page 86)

CLI commands 86
The parameters enable the addition of all chassis on all SL-APM ports, all the chassis plugged into an
SL-APM port through a SL-APM Distribution Module) or a specific chassis on a specified SL-APM port
and SL-APM Distribution Module port. The syntax is similar to other SL-APM commands such as SHOW
POWER or SHOW RACK in how SL-APM and SL-APM Distribution Module ports are specified.
When adding a chassis to a zone, the chassis does not have to be present and plugged into the
SL-APM. The SL-APM issues a message in such cases, and therefore, the chassis does not exist. Zone
definitions do not require the hardware to be present . For SL-APM operations that might use zones (for
example, SET POWER BASELINE), only those chassis that exist and are defined in the zone are
considered for the operation.
Examples:
ADD ZONE my_zone 1 5
Adds the chassis plugged into SL-APM Distribution Module port 5 on SL-APM port 1 to zone MY_ZONE.
If MY_ZONE did not already exist, it will be created.
ADD ZONE my_zone 1 all
Adds all the chassis plugged into an SL-APM Distribution Module on SL-APM port 1.
ADD ZONE my_zone all
Adds all chassis on the SL-APM to zone MY_ZONE.
ADD ZONE BLUE 1 ALL 2 ALL 3 1
You can also use ALL by itself instead of a PORT DMPORT pair.
For example:
ADD ZONE BLUE ALL
Zones cannot overlap.
Save zones
• Command:
SAVE ZONES
• Description:
o Commits the defined zones and their member chassis to the on-board EEPROM.
o You can define and save up to four zones. These zones are automatically loaded from the EEPROM
when the board is reset.
Show zones
• Command:
SHOW ZONES
• Description:
Displays all the currently defined zones and their respective member chassis.
Remove zone
• Command:
REMOVE ZONE [[ ]] | [ ALL] | [ALL]