HP ProLiant DL170e G6 Server - Manual (Page 54)

General commands 54
When entering a password in this manner, you must include quotation marks around the password being set.
This form of command is useful for scripted setup.
Disabling SL-APM passwords
To disable the password, enter DISABLE PASSWORD.
This command disables the password protection feature. If the password is disabled, SSH and Telnet access
are also disabled.
Resetting factory settings for SL-APM
To restore the SL-APM to its factory default settings, enter RESET FACTORY.
This command restores SL-APM to factory settings, including no password and Ethernet access, and then
performs a reboot.
WARNING: When you enter RESET FACTORY, SL-APM erases your entire configuration. Before
resetting factory defaults, consider saving your configuration. For more information on
duplicating your configuration, see "Duplicating the configuration (on page
26 )".
Working with accounts
SL-APM supports two login accounts (including the built-in Administrator account) on a single SL-APM board.
Adding an account
To add an account, enter ADD ACCOUNT. For example, enter
myslapm> add account "root"
Password must be at least 8 characters
Note: password will not show.
Enter account "root" password:
Enter account "root" password (again):
Saving password..done.
Account root enabled
myslapm>
After you enter this command with a valid new username, a prompt asking for a password appears. Enter the
password. The new account is available for system login.
If you do not specify a password, and the username does not already exist, then you are prompted for a
password.
All user accounts have the same permissions.
NOTE: Login accounts and passwords are stored separate from the board configuration. A
SHOW CONFIG command will not reveal any ADD ACCOUNT commands.
Removing an account
To remove an account, enter REMOVE ACCOUNT “”