HP ProLiant DL170e G6 Server - Manual (Page 72)

Troubleshooting 72
Troubleshooting
Alert messages
The following messages appear in SL-APM.
Message Where this issue occurs Required action
There was an error
transferring the file,
image upgrade not
performed.
Firmware upgrade Verify network connectivity, and then retry the
firmware upgrade.
Error upgrading
firmware image.
Firmware upgrade Message appears with other logs describing the
actual issue. Review logs to identify, and then
resolve issue.
Dist. Module on Power
Manager Chassis port
<#> has excessive
errors and has been
marked as failed.
All modes of operation Verify SL-APM and SL-APM Distribution Module
cabling.
Power Manager Chassis
port <#> on Dist.
Module <#> has
excessive errors and
has been marked as
failed.
All modes of operation Verify SL-APM and SL-APM Distribution Module
cabling.
Power Manager Chassis
rendered non
functional, redundant
Power Manager Chassis
is not supported by
this firmware version.
Redundant SL-APM inserted
into SL-APM enclosure
Remove both SL-APM controllers, and then
reinsert only one controller.
The SL enclosure on
Power Manager port
<#>, Dist. Module port
<#> does not support
the Power Manager.
SL Power Management
Controller at the named
location does not support
SL-APM.
Update the SL Power Management Controller in
that chassis. If no update is available, the SL
Power Management Controller does not offer
support for SL-APM.
For messages not listed, contact HP Support ( http://www.hp.com/support ). For more information, see
"Support and other resources (on page 106 )."
Devices not discovered
If devices are not discovered, perform the following steps:
1. Check the link and power LEDs.
2. Check the cables.
3. Reboot SL-APM.