HP ProLiant DL170e G6 Server - Manual (Page 80)

CLI commands 80
Set time
• Command:
SET TIME
where:
is the month.
is the day.
is the year.
is the hour, in 24-hour format. For example, enter 3:00 p.m. as 15.
is the minute.
SL-APM does not automatically adjust for Daylight Savings Time.
The time remains on this setting until you issue the RESET FACTORY command.
• Description:
o Sets the system time on the battery-backed clock.
o All five parameters must be present. The hour parameter must be in 24-hour format.
Set timeout
• Command:
SET TIMEOUT { | NONE}
where:
is the session timeout value measured in seconds. For example, to set a 30-second
session timeout, enter:
SET TIMEOUT 30
If you specify NONE, then no session timeouts are set. For example, enter:
SET TIMEOUT NONE
• Description:
Sets the SSH and Telnet inactivity timeout.
Set power baseline
• Command:
SET POWER BASELINE
• Description:
Baseline or calibrate all servers that are connected to the SL-APM. After you have established a baseline
for the configuration, it is saved into the EEPROM on the SL-APM and the configuration monitored for
changes from the baseline configuration. Examples of changes to the configuration would include the
removal or installation of servers or chassis. If SL-APM is reset, the baseline is re-read from the EEPROM
and compared to the discovered configuration after reset.
The baseline is computed for the entire configuration and is not applicable to zones. When a power
cap is set, the baseline data establishes the minimum and maximum power values that can be used for
the cap. If you set a cap with a defined zone specified, then only that baseline data that was established