HP ProLiant DL170e G6 Server - Manual (Page 24)

Installation and configuration 24
• Enter the commands manually. This procedure is for advanced users who want more control over the
configuration process.
• Duplicate the configuration. For more information, see "Duplicating the configuration (on page 26 )."
Using the configuration wizard
When you enter CONFIG, you are prompted to complete the following tasks.
1. Set the onboard clockIf you select Y, you will be prompted to enter:
o MonthEnter a value between 1 to 12. Press Enter.
o DayEnter a value between 1 to 31. Press Enter.
o YearEnter the year (value must be four digits). Press Enter.
o HourEnter a value between 0-23. Press Enter.
o MinutesEnter a value between 0-59. Press Enter.
2. Name the power managerIf you select Y, enter a name for the power manager. System names can
be up to 80 characters. It can include uppercase letters, lowercase letters, underscores (_), dashes (-),
the dollar sign ($), and numerical values between 0-9. To save the power manager name, press Enter.
Naming the SL-APM is optional. This is the name that will appear in log entries on the syslog server as
well as the CLI prompt.
3. Enable password protectionSL-APM has no default password. If you select Y, enter a password. The
password must be between 8 and 40 characters, and can include:
o uppercase letters
o lowercase letters
o underscores (_)
o dashes (-)
o at signs (@)
o pound signs (#)
o carets (^)
o ampersands (&)
o exclamation points (!)
o plus symbols (+)
o equal symbols (=)
o tilde (~)
o numerical values between 0–9
To save and enable the password, press Enter. For more information about working with passwords,
see "Working with passwords (on page
53 )."
4. Configure the Ethernet port.
5. Use DHCP.
6. Enter an IP address.
7. Enter an IP address mask.
8. Enable Telnet.
9. Enable SSH.
10. To review the enabled configuration before saving it, select Y.