HP ProLiant DL170e G6 Server - Manual (Page 85)

CLI commands 85
Displays the currently set system time.
Show power baseline
• Command:
SHOW POWER BASELINE
• Description:
Reports the currently established baseline data for all chassis that are connected to the SL-APM.
Show version
• Command:
SHOW VERSION
SHOW VERSION ALL
• Description:
o Displays SL-APM firmware copyright, version, build date, and hardware version. Also displays
SL-APM Distribution Module hardware and firmware versions.
o SHOW VERSION ALL shows the HP Power Management Controller Utility hardware and firmware
versions as well as the license status of all servers in the enclosures.
Upgrade image
• Command:
o If using TFTP protocol for upgrading SL-APM, enter:
UPGRADE IMAGE TFTP ""
o If using FTP protocol for upgrading SL-APM, enter:
UPGRADE IMAGE FTP "" "" ""
• Description:
o Updates SL-APM firmware using the specified protocol. Protocol can be either FTP or TFTP.
refers to the IP address of a server that contains the file to be transferred, and
filename is the file to be transferred. Following the transfer, SL-APM will be upgraded and reset to
run the new image.
o The filename must be enclosed in quotes to preserve case.
Add zone
• Command:
ADD ZONE [[ ]] | [ ALL] | [ALL]
• Description:
Adds one or more chassis to a zone named by . If the zone does not already exist, then
it will be automatically created and the specified chassis will be added.
You can create up to four zones.