HP ProLiant DL170e G6 Server - Manual (Page 58)

General commands 58
o To reset the password, enter SET PASSWORD. For more information, see "Setting SL-APM
passwords (on page 53 )".
o To disable the password, enter DISABLE PASSWORD, and then SAVE. For more information, see
"Disabling SL-APM passwords (on page 54 )".
7. Remove the SL-APM controller from the SL-APM enclosure.
8. Locate the switches.
9. Set switch 1 to OFF.
10. Reinsert the SL-APM controller into the SL-APM enclosure.
Showing configurations
To show the configuration, enter SHOW CONFIG. A list of commands representing the configuration of
SL-APM appears.
Using the help
To access the help, enter HELP. The following listing appears:
SL-APM> help
CLEAR Empty log entries
CONFIG Configure SL-APM
DISABLE Turn off board features
ENABLE Turn on board features
EXIT Exit CLI
HELP Show help messages
LOGOUT Exit CLI
PING Ping a remote host
REBOOT Reboot firmware
RESET Reset SL-APM
SAVE Save SL-APM configuration
SET Set board configuration
SHOW Display information
UPGRADE Pull in new firmware
Each listing, in turn, has its own listings. For example, entering HELP CLEAR, the following listing appears:
SL-APM> help clear
CLEAR Empty log entries
FAULTS Empty the fault log
LOG Empty system log
SCREEN Clear the screen
This listing shows the items that you can clear:
• To empty the fault log, enter CLEAR FAULTS.
• To empty the system log, enter CLEAR LOG.
• To clear the screen, enter CLEAR SCREEN.
Setting the name
To set the name that will appear in the log and syslog entries, enter SET NAME "". For example: