HP ProLiant DL170e G6 Server - Manual (Page 81)

CLI commands 81
for the enclosures and are within that zone are used to establish the minimum and maximum for the cap
to that zone.
Set power cap
• Command:
SET POWER CAP |NONE [zone_name]
• Description:
o Establishes a power cap for all the eligible chassis that are connected to the SL-APM.
The wattage value, if provided, represents the total wattage to be allocated among all the chassis
that are part of the baseline or partial baseline if a zone, if specified. This value is divided by the
total maximum wattage established by the baseline to come up with a percentage cap value. This
percentage is then multiplied against each chassis maximum wattage value to arrive at an
appropriate cap value for that individual chassis.
o If you specify NONE instead of a cap wattage value, then SL-APM removes all (or those in the
specified zone, if desired) of the power caps.
Set asset info
• Command:
SET ASSETINFO [PDM1|PDM2] ""
• Description:
o Enables SL-APM to set an asset tag. Supported only on the HP 60A PDU.
o The can be up to 32 characters in length. The string will be programmed
into the PDU and can be retrieved with the SHOW ASSETINFO command.
Show accounts
• Command:
SHOW ACCOUNTS
• Description:
Shows the existing defined accounts, including the reserved Administrator account.
Show config
• Command:
SHOW CONFIG
• Description:
Displays the current configuration commands for SL-APM.
Show faults
• Command: