HP ProLiant DL170e G6 Server - Manual (Page 27)

Command Line Interface 27
Command Line Interface
Command line conventions
CLI input is case insensitive except when otherwise noted. The CLI uses a simple, case insensitive verb noun
"" syntax.
Each command follows the conventions listed in the following table.
Symbol Description
Denotes the variable within the symbols that must be substituted with a value, such as
a user name. Symbols must be removed.
UPPER CASE Denotes input to be entered as shown.
Unless noted, symbol is not case-sensitive.
| Used to separate input options.
{ } Denotes a list of mandatory choices that you must make.
For example, SET GATEWAY {NONE | } must be in the form of either
of the following:
• SET GATEWAY NONE
• SET GATEWAY
[ ] Denotes an optional argument or set of characters.
" " Encloses command arguments that contain spaces.
Accessing the SL-APM command line interface
You can access the SL-APM through SSH, Telnet, or the serial port.
Accessing the SL-APM through SSH
1. Using any SSH client application, start a SSH session to SL-APM.
2. When prompted, enter the assigned IP address or FQDN of SL-APM.
3. Enter Administrator.
4. Enter a valid password. The CLI command prompt appears.
5. Enter commands for SL-APM.
6. To terminate the remote access SSH session, close the communication software or enter EXIT,
LOGOUT, or QUIT at the CLI command prompt.
Accessing the SL-APM through Telnet
1. Start a Telnet session to SL-APM using any Telnet client application.